Instrument Cluster and Display

Instrument Cluster (Type A)

Odometer, Trip Meter and Trip Meter Selector

The odometer is constantly displayed on the screen when the ignition is switched ON, and the TRIP A or TRIP B screen can be displayed by operating the INFO switch.

 

Odometer

The odometer records the total distance the vehicle has been driven.

Trip meter

The driving distance for a specified interval is indicated. Two types (TRIP A, TRIP B) of interval distance and the average fuel economy for each can be measured.

 

For instance, trip meter A can record the distance from the point of origin, and trip meter B can record the distance from where the fuel tank is filled.

 

When trip meter A is selected, TRIP A will be displayed. When trip meter B is selected, TRIP B will be displayed.

 

The trip meter and average fuel economy can be reset by pressing the INFO switch for 1.5 seconds or more while in each mode.

 

  • Only the trip meters record tenths of kilometers (miles).

  • The trip record will be erased when:

    • The power supply is interrupted (blown fuse or the battery is disconnected).

    • The vehicle is driven over 9999.9 km (mile).

Close Note
View Note

Engine Coolant Temperature Gauge

Displays the engine coolant temperature. The blue range of the gauge indicates that the engine coolant temperature is low, and the red range of the gauge indicates that the engine coolant temperature is high and overheating.

 

 

If the engine coolant temperature gauge needle is in the red range, there is the possibility of overheating. Drive slowly to reduce engine load until you can find a safe place to stop the vehicle and wait for the engine to cool down.

Refer to Overheating (Search).

Close Caution
View Caution

 

  • (SKYACTIV-G 2.5T, SKYACTIV-D 2.2)

    If the engine coolant temperature is high or the engine is hot, the engine output may be limited.

Close Note
View Note

Wrench Indication

The wrench indication is displayed under the following conditions.

  • When the preset maintenance period has arrived.

    Refer to the Information section in the Mazda Connect Owner's Manual.

  • When the engine oil replacement period has arrived.

  • (SKYACTIV-D 2.2)

    • When the engine oil is deteriorated or exceeds the specified amount.

    • When fuel filter (sedimentor) draining is required. Consult an Authorized Mazda Dealer.

 

  • The wrench indication may display earlier than the preset period depending on vehicle usage conditions.

  • Whenever the engine oil is replaced, a reset of the vehicle engine control unit is necessary.

    Refer to the Information section in the Mazda Connect Owner's Manual.

Close Note
View Note

 

Page top