Specifications

Specifications

Charge System

Item

Servicing data

Input power

110 - 240 V AC

Rated frequency

60 Hz

Maximum rated electrical current

32 A (normal charge)

Maximum power consumption

7.2 kVA (normal charge)

Maximum charging current

150 A (quick charge)

Electrical leakage detection current for control box including genuine charge cable

5 mA

EV charge mode/Connection type

Normal charge: AC Level 1, AC level 2

Quick charge: CCS1 (Combo1)

Connection Type : TYPE1

Installation requirements

(information on protection against short-circuit current and equipment protection)

Applicable laws and regulations, and standards must be followed for protection measures against over-current and over-voltage.

Always make sure to install appropriate over-current protection devices to the wiring of houses and buildings.

IP level

IP44: When charge connector is connected to charge inlet

IP67: EV Supply Equipment(Charging Cable)

Operating temperature

Onboard charger: -30 °C (-22 °F) ― 85 °C (185 °F) (ambient temperature), -30 °C (-22 °F) ― 65 °C (149 °F) (coolant temperature)

EV Supply Equipment(Charging Cable) : -30 °C (-22 °F) ― 55 °C (131 °F) (ambient temperature)

Storage temperature

Onboard charger: -40 °C (-40 °F) ― 85 °C (185 °F) (coolant temperature), -40 °C (-40 °F) ― 85 °C (185 °F) (ambient temperature)

EV Supply Equipment(Charging Cable) : -40 °C (-40 °F) ― 80°C (176 °F) (ambient temperature)

Applicable standards

Onboard charger: EN/IEC 61851-1, EN/IEC 61851-21, EN/IEC 61851-23, UL 2202

EV Supply Equipment(Charging Cable) : NFPA 70, NFPA 79, SAE-J 1772, UL 62, UL 817, UL 2231-1, UL 2231-2, UL 2251, UL 2594, CSA C22.2 No.280-16

Adapters

Do not use an adapter on the charge plug and the charge connector.

Do not use an extension cable.

High Voltage Battery

Item

Specification

Type

Lithium-ion battery

Temperature range

Operation guaranteed temperature: -30 °C (-22 °F) ― 60 °C (140 °F)

Storage guaranteed temperature: -40 °C (-40 °F) ― 70 °C (158 °F)

Lead-acid Battery

Item

Specification

Lead-acid battery*1

LN1 (12V-42Ah/20HR)

  1. Check the battery installed on the vehicle and use a battery with an equal or higher performance. However, the performance of the battery may vary even among the same battery types, consult an Authorized Mazda Dealer for replacement.

Lubricant Quality

Lubricant

Classification

Coolant

FL-22 type

EV Transaxle fluid

Mazda Original Oil ATF-FZ

Brake fluid

SAE J1703 or FMVSS116 DOT-3

Capacities

(Approximate Quantities)

Item

Capacity

Coolant

4.3 L (4.5 US qt, 3.8 Imp qt)

EV Transaxle fluid

1.55 L (1.64 US qt, 1.36 Imp qt)

Check oil and fluid levels with dipsticks or reservoir gauges.

Dimensions

Item

Vehicle specification

Overall length

4,393 mm (173.0 in)

Overall width

1,797 mm (70.7 in)

Overall height

1,574 mm (62.0 in)

Front tread

1,563 mm (61.5 in)

Rear tread

1,563 mm (61.5 in)

Wheelbase

2,653 mm (104.4 in)

Weights

Item

Weight

GVWR (Gross Vehicle Weight Rating)

2,087 kg (4,601 lbs)

GAWR (Gross Axle Weight Rating)

Front

1,047 kg (2,308 lbs)

Rear

1,042 kg (2,297 lbs)

Light Bulbs

Exterior light/Interior light

All the light bulbs are the LED type.

The LED bulb cannot be replaced. Consult an Authorized Mazda Dealer when the replacement is necessary.

Tires

 


The tires have been optimally matched with the chassis of your vehicle.

When replacing tires, Mazda recommends that you replace tires of the same type originally fitted to your vehicle. For details, contact an Authorized Mazda Dealer.

Check the tire pressure label for tire size and inflation pressure.

  • Refer to Tire Pressure Label (Search).

Standard tire

Tire size

Inflation pressure

Front

Rear

215/55R18 95H M+S

250 kPa (36 psi)

250 kPa (36 psi)

Lug nut tightening torque

When installing a tire, tighten the lug nut to the following torque.

108―147 N·m (12―14 kgf·m, 80―108 ft·lbf)

Page top