Vehicle Specification
Engine
|
Item |
Specification |
|
|---|---|---|
|
Type |
DOHC-16V in-line, 4-cylinder |
|
|
Bore × Stroke |
89.0 × 100.0 mm (3.50 × 3.94 in) |
|
|
Displacement |
2,488.5 ml (2,488.5 cc) |
|
|
Compression ratio |
13.0 |
|
Charge System
|
Item |
Servicing data |
|---|---|
|
Input power |
110 - 240 V AC |
|
Rated frequency |
60 Hz |
|
Maximum rated electrical current |
In normal charge 32A AC |
|
Maximum power consumption |
7.2 kVA (normal charge) |
|
Electrical leakage detection current for control box including genuine charge cable |
5 mA |
|
EV charge mode/Connection type |
Normal charge: Mode 2, Mode 3/TYPE1 |
|
Installation requirements (information on protection against short-circuit current and equipment protection) |
Applicable laws and regulations, and standards must be followed for protection measures against over-current and over-voltage. Always make sure to install appropriate over-current protection devices to the wiring of houses and buildings. |
|
IP level |
IP44: When charge connector is connected to charge inlet IP67 : Charging Cable |
|
Operating temperature |
On Board Charger Ambient temperature : －30 °C (－22 °F) to 85 °C (185 °F) coolant temperature : －30 °C (－22 °F) to 70 °C (158 °F) Charging Cable Ambient temperature : －30 °C (－22 °F) to 55 °C (131 °F) |
|
Storage temperature |
On Board Charger Ambient temperature : －40 °C (－40 °F) to 85 °C (185 °F) coolant temperature : －40 °C (－40 °F) to 85 °C (185 °F) Charging Cable Ambient temperature : －40 °C (－40 °F) to 80 °C (176 °F) |
|
Applicable standards |
On Board Charger EN/IEC 61851-1, EN/IEC 61851-21, EN/IEC 61851-23, UL 2202 Charging Cable NFPA 70, NFPA 79, SAE-J 1772, UL 62, UL 817, UL 2231-1, UL 2231-2, UL 2251, UL 2594, CSA C22.2 No.280-16 |
|
Adapters |
Do not use an adapter with the plug and connector of the charging cable. Do not use an extension cable. |
High Voltage Battery
|
Item |
Specification |
|---|---|
|
Type |
Lithium-ion battery |
|
Temperature range |
Operation guaranteed temperature: －30 °C (－22 °F) ― 60 °C (140 °F) Storage guaranteed temperature: －40 °C (－40 °F) ― 70 °C (158 °F) |
Electrical System
|
Classification |
Specification |
|
|---|---|---|
|
Lead-acid battery*1 |
Q-85 |
|
|
Spark-plug number |
Mazda Genuine spark plug*2 |
PE5R-18-110-A or PE5S-18-110 |
-
The battery specification differs depending on the country or region. Check the battery installed on the vehicle and use a battery with an equal or higher performance. However, the performance of the battery may vary even among the same battery types, consult an Authorized Mazda Dealer for replacement.
-
This spark plug provides the e-SKYACTIV PHEV engine with optimum performance. Contact an Authorized Mazda Dealer for details.
When cleaning the iridium plugs, do not use a wire brush. The fine particulate coating on the iridium alloy and platinum tips could be damaged.
Lubricant Quality
|
Lubricant |
Classification |
|---|---|
|
Engine oil |
Refer to Recommended Oil (Search). |
|
Coolant |
FL-22 type |
|
Automatic transmission fluid*1 |
Mazda Original Oil ATF-A7 |
|
Transfer case oil*2 |
|
|
Front differential oil*2 |
Mazda Long Life Hypoid Gear Oil SG1 |
|
Rear differential oil*2 |
|
|
Brake fluid |
Mazda Genuine Brake Fluid or equivalent |
-
Periodic replacement is unnecessary.
-
Replacement is necessary when the component is submerged in water.
Refer to Inspection and Servicingon (Search) for owner's responsibility in protecting your investment.
Capacities
(Approximate Quantities)
|
Item |
Capacity |
|
|
Engine oil |
With oil filter replacement |
4.5 L (4.8 US qt, 4.0 Imp qt) |
|
Without oil filter replacement |
4.3 L (4.5 US qt, 3.8 Imp qt) |
|
|
Coolant |
EV system |
6.5 L (6.9 US qt, 5.7 Imp qt) |
|
Engine |
9.2 L (9.7 US qt, 8.1 Imp qt) |
|
|
Automatic transmission fluid |
7.3 L (7.7 US qt, 6.4 Imp qt) |
|
|
Transfer case oil |
0.51 L (0.54 US qt, 0.45 Imp qt) |
|
|
Front differential oil |
0.35 L (0.37 US qt, 0.31 Imp qt) |
|
|
Rear differential oil |
0.90 L (1.0 US qt, 0.8 Imp qt) |
|
|
Fuel tank |
70.0 L (18.5 US gal, 15.4 Imp gal) |
|
Check oil and fluid levels with dipsticks or reservoir gauges.
Dimensions
|
Item |
Vehicle specification |
|
|---|---|---|
|
Overall length |
5,100 mm (200.8 in) |
|
|
Overall width |
1,994 mm (78.5 in) |
|
|
Overall height |
Without roof rail |
1,740 mm (68.5 in) |
|
With roof rail |
1,745 mm (68.7 in) |
|
|
Front tread |
1,705 mm (67.1 in) |
|
|
Rear tread |
1,708 mm (67.2 in) |
|
|
Wheelbase |
3120 mm (122.8 in) |
|
Weights
|
Item |
19 inch wheel vehicle |
21 inch wheel vehicle |
|
|---|---|---|---|
|
GVWR (Gross Vehicle Weight Rating) |
3,109 kg (6,854 lbs) |
||
|
GAWR (Gross Axle Weight Rating) |
Front |
1,320 kg (2,910 lbs) |
1,313 kg (2,895 lbs) |
|
Rear |
1,855 kg (4,090 lbs) |
1,797 kg (3,962 lbs) |
|
Light Bulbs
Exterior light/Interior light
All the light bulbs are the LED type.
The LED bulb cannot be replaced as a single unit because it is an integrated unit.
The LED bulb has to be replaced with the unit. If a replacement is necessary, consult an Authorized Mazda Dealer.
Tires
Sample tire mark and its meaning
-
Nominal section width
-
Nominal aspect ratio in %
-
Construction code
-
Nominal rim diameter in inches
-
Load index (not on ZR tires)
-
Speed symbol
-
Mud and snow
Tire mark information
Choose the proper tires for your vehicle using the following tire mark information.
|
Speed symbol |
Maximum permissible speed |
|---|---|
|
Q |
Up to 160 km/h (99 mph) |
|
R |
Up to 170 km/h (105 mph) |
|
S |
Up to 180 km/h (111 mph) |
|
T |
Up to 190 km/h (118 mph) |
|
U |
Up to 200 km/h (124 mph) |
|
H |
Up to 210 km/h (130 mph) |
|
V |
Up to 240 km/h (149 mph) |
|
W |
Up to 270 km/h (167 mph) |
|
Y |
Up to 300 km/h (186 mph) |
|
ZR |
Over 240 km/h (149 mph) |
Tire and inflation pressure
The tires have been optimally matched with the chassis of your vehicle.
When replacing tires, Mazda recommends that you replace tires of the same type originally fitted to your vehicle. For details, contact an Authorized Mazda Dealer.
Check the tire pressure label for tire size and inflation pressure.
Refer to Tire Pressure Label (Search).
Standard tire
(U.S.A. and Canada)
|
Tire size |
Inflation pressure |
|
|---|---|---|
|
Front |
Rear |
|
|
265/55R19 109V |
250 kPa (2.5 bar, 36 psi) |
250 kPa (2.5 bar, 36 psi) |
|
275/45R21 110W*1 |
250 kPa (2.5 bar, 36 psi) |
270 kPa (2.7 bar, 39 psi) |
Single occupant’s weight: About 75 kg
-
Before driving at high speeds, increase the pressure of the tires. For speeds above 175 km/h (109 mph), increase the pressure of the tires by 40 kPa (0.4 bar, 5.8 psi).
After high-speed driving, returning to standard tire pressure is recommended.
Temporary spare tire (Some Models)
|
Tire size |
Inflation pressure |
|---|---|
|
T155/90D18 113M |
420 kPa (4.2 bar, 60 psi) |
Lug nut tightening torque
When installing a tire, tighten the lug nut to the following torque.
108―147 N·m (12―14 kgf·m, 80―108 ft·lbf)
