Using Connected Service

Using Send to Car

Send to Car is a function which uses the MyMazda APP to search the destination of the navigation and send it to the vehicle.
First, use the MyMazda APP and select a destination to be sent to the vehicle.

Then Search for the destination that you wish to set or search for the destination using the map by touching [MAP] on the home screen.
You can also set any region on the map and search for a destination.

If you receive a destination when driving in the vehicle, avoid any distractions and do not divert your attention away from driving the vehicle.
To use the navigation system, the SD card containing the map information needs to be inserted in the SD card slot.
Send to Car can send up to three destinations concurrently.
Navigation pathways must be set for the respective destinations received.
When sending multiple destinations, it is convenient to send them all at once instead of sending them one after another.
When the ignition switch/power switch is switched OFF, the vehicle cannot receive the destination. When the ignition switch/power switch is switched ON, the sent destination is received.
If a location where a route search is not possible such as over water is sent, the destination of the navigation route will not be set by the vehicle.
Up to 10 destinations can be set to the navigation route. If you exceed the maximum number of destinations sent by Send to Car, either discard the routes the vehicle already set and set the received destination as the new destination, or cancel the received destination.

When editing a navigation pathway, refer to the NAVIGATION SYSTEM Owner’s Manual.

When Sending One Destination

1.	Display the detailed information for the destination that was searched.

2.	Touch SEND TO CAR.

The destination is automatically received by the vehicle.

If a Navigation Route Has Not Been Created by the Vehicle
When setting the route using the received destination, select [Create] and edit the navigation route.
If a Navigation Route Setting by the Vehicle Has Been Completed
Select whether the received destination is to be set as a new destination or to be added to the existing route.
To discard the existing route and set a new route, select [Replace].
To add to the existing route, select [Add] and edit the navigation route for each destination.

When adding a destination to an existing navigation route, select a position to insert as shown in the figure.
Add (2), (3) as transit points with (1) as the final destination.

When Sending Multiple Destinations

1.	Display the detailed information for the first destination that was searched.

Touch [Location] (), and add the second destination.
For the last spot, touch SEND TO CAR, which collectively sends points up to this point to the vehicle.

Up to three destinations can be sent at a time. Touch [Location] at the first and second destinations, then touch SEND TO CAR at the third destination to send the three destinations.
The same destination cannot be sent repeatedly.

The destinations are automatically received by the vehicle.

If a Navigation Route Has Not Been Created by the Vehicle
When setting the route using the received destination, select [Create] and edit the navigation route.
If a Navigation Route Setting by the Vehicle Has Been Completed
Select whether the received destination is to be set as a new destination or to be added to the existing route.
To discard the existing route and set a new route, select [Replace].
To add to the existing route, select [Add] and edit the navigation route for each destination.

If destinations are to be added to the existing navigation route, they are inserted in the ★ area in the order they were set in the MyMazda APP. If the positions differ from your intended positions, edit the navigation route to arrange the order of the destinations.