Spare Tire and Tool Storage
Jack
To remove the jack
-
Remove the luggage board.
To secure the jack
Perform the removal procedure in reverse.
Maintenance
-
Always keep the jack clean.
-
Make sure the moving parts are kept free from dirt or rust.
-
Make sure the screw thread is adequately lubricated.
Spare Tire
The temporary spare tire is lighter and smaller than a conventional tire, and is designed only for emergency use and should be used only for VERY short periods. Temporary spare tires should NEVER be used for long drives or extended periods.
Do not install the temporary spare tire on the front wheels (driving wheels).
Driving with the temporary spare tire on one of the front driving wheels is dangerous. Handling will be affected. You could lose control of the vehicle, especially on ice or snow bound roads, and have an accident. Move a regular tire to the front wheel and install the temporary spare tire to the rear.
-
When using the temporary spare tire, driving stability may decrease compared to when using only the conventional tire. Drive carefully.
-
To avoid damage to the temporary spare tire or to the vehicle, observe the following precautions:
-
Do not exceed 80 km/h (50 mph).
-
Avoid driving over obstacles. Also, do not drive through an automatic car wash. This tire's diameter is smaller than a conventional tire, so the ground clearance is reduced.
-
Do not use a tire chain on this tire because it will not fit properly.
-
Do not use your temporary spare tire on any other vehicle, it has been designed only for your Mazda.
-
Use only one temporary spare tire on your vehicle at the same time.
-
To remove the spare tire
-
Remove the luggage board.
-
(Vehicles with sub-woofer)
Uncouple the sub-woofer connector.
Extra strength may be required to uncouple the connector. Be sure to squeeze the tab firmly.
-
(Vehicles with sub-woofer)
Turn the spare tire hold-down bolt counterclockwise and remove the sub-woofer and the spare tire.
(Vehicles without sub-woofer)
Turn the spare tire hold-down bolt counterclockwise and remove the spare tire.
If the spare tire hold-down bolt cannot be loosened, hold the edge of the tire and turn it counterclockwise until the spare tire hold-down bolt rotates.
To secure the spare tire
Store the spare tire in the reverse order of removal. After storing, verify that the spare tire is stored securely.
