Warning/Indicator Light Turns On
High Engine Coolant Temperature Warning Light
The light turns on if the engine coolant temperature has increased excessively.
Check the contents of the message displayed and take the necessary action.
Do not drive the vehicle with the high engine coolant temperature warning light turned on. Driving the vehicle with the engine not cooled down may cause engine damage.
Air Bag/Seat Belt Pretensioner System Warning Light
A problem in the system might be indicated under the following conditions.
Have your vehicle inspected by an Authorized Mazda Dealer.
-
Does not turn on even if the vehicle power is switched ON.
-
Remains turned-on/flashing.
Never tamper with the air bag/pretensioner systems and always have an Authorized Mazda Dealer perform all servicing and repairs.
Self-servicing or tampering with the systems is dangerous. An air bag/pretensioner could accidentally activate or become disabled causing serious injury or death.
Security Indicator Light
If the security indicator light turns on/flashes while driving, do not stop the engine (leave it operating) and have the vehicle inspected at an Authorized Mazda Dealer. If you stop the engine , you may not be able to start it again.
If the engine cannot be started, switch the vehicle power OFF, place the key in another position within the operation range, and then restart the engine.
Check the security indicator light and if it does not turn off, such as it remains on or flashes, switch the vehicle power OFF, wait for a while, and then restart the engine.
If the engine does not start after three attempts, a system malfunction may have occurred. Have the vehicle inspected by an Authorized Mazda Dealer.
When repairing the immobilizer system, the key codes will need to be reprogrammed. Bring all the remaining keys to an Authorized Mazda Dealer.
Low Fuel Warning Light
The light turns on/flashes when the remaining fuel in the tank is near empty.
When the light flashes, a warning sound is activated.
Refuel immediately.
The light illumination timing may vary because fuel inside the fuel tank moves around according to the driving conditions and the vehicle posture.
Check Fuel Cap Warning Light
If the check fuel cap warning light illuminates while driving, the fuel-filler cap may not be installed properly.
Stop the engine and reinstall the fuel-filler cap.
Rear Seat Alert Warning Light (Some Models)
The warning light turns on continuously if the system has a problem. Have the vehicle inspected by an Authorized Mazda Dealer.
Low Washer Fluid Amount Warning Light (Some Models)
The light turns on if the amount of washer fluid is low when the vehicle power is switched ON.
Add washer fluid.
Wrench Indicator Light
The wrench indication/indicator light is displayed/turns on under the following conditions.
-
When the preset maintenance period has arrived.
Refer to the Information section in the Mazda Connect Owner's Manual.
-
When the maintenance period arrives, have your vehicle inspected by an Authorized Mazda Dealer as soon as possible. If maintenance is neglected, a decrease in vehicle performance may occur which could cause damage. Have your vehicle inspected before the maintenance period arrives.
-
If the vehicle continues to be driven after the engine oil replacement period has passed, it could cause damage to the engine. Replace the engine oil before the maintenance period arrives.
-
-
The wrench indication/indicator light may display/turn on earlier than the preset period depending on vehicle usage conditions.
-
Whenever the engine oil is replaced, a reset of the vehicle engine control unit is necessary.
Refer to the Information section in the Mazda Connect Owner's Manual.
