Instrument Cluster

Instrument Cluster

  1. Multi-information Display

  2. Dashboard Illumination Switch

  3. Tachometer

  4. Speedometer

Tachometer

The tachometer shows engine speed in thousands of revolutions per minute (rpm).

 


Do not run the engine with the tachometer needle in the RED ZONE.

This may cause severe engine damage.

 

  1. STRIPED ZONE

  2. RED ZONE

 


When the tachometer needle enters the STRIPED ZONE, this indicates to the driver that the gears should be shifted before entering the RED ZONE.

Multi-information Display

The screen display informs you of the vehicle information.

 

The multi-information display indicates the following information.

  • Odometer

  • Trip meter

  • Engine coolant temperature gauge

  • Fuel gauge

  • Outside temperature

  • Maximum driving distance

  • Average fuel economy

  • Current fuel economy

  • i-ACTIVSENSE display

  • Door-ajar/trunk lid-open warning indication*1

  • Compass Display

  • Roof Operation Display (Hardtop)

  • Message display

  1. Displayed when opening door/trunk lid.

How to Use the Multi-information Display

The screen content changes each time the INFO switch is pressed.

  1. Trip A display

  2. Trip B display

  3. i-ACTIVSENSE display

  4. Compass Display/Maximum driving distance display

  5. Message display*1

  1. Displayed only when a warning occurs.

Odometer/Trip Meter

Odometer

The odometer records the total distance the vehicle has been driven.

Trip meter

The driving distance for a specified interval is indicated. Two types (TRIP A, TRIP B) of interval distance can be measured.

Engine Coolant Temperature Gauge

Displays the engine coolant temperature. The blue range of the gauge indicates that the engine coolant temperature is low, and the red range of the gauge indicates that the engine coolant temperature is high and overheating.

The engine coolant temperature gauge can be switched to indicate only the high engine coolant temperature range by pressing the dashboard illumination switch.

 


If the engine coolant temperature gauge needle is in the red range, there is the possibility of overheating. Drive slowly to reduce engine load.

Refer to Taking Action with Overheating (Search).

Fuel Gauge

The fuel gauge shows approximately how much fuel is remaining in the tank when the vehicle power is switched ON.

When the fuel tank is full, F (Full) is indicated, and as the level lowers the needle approaches E (Empty).

 

 


  • After refueling, it may require some time for the indicator to stabilize. In addition, the indicator may deviate while driving on a slope or curve since the fuel moves in the tank.

  • The direction of the arrow indicates that the fuel-filler lid is on the left side of the vehicle.

How to Use the Dashboard Illumination

  1. Dim

  2. Bright

 

A beep sound will be heard when the knob has been rotated to the maximum dim position.

Function for canceling illumination dimmer

The illumination dimmer can be cancelled by rotating the instrument panel illumination knob to the right until a beep sound is heard while the instrument cluster is dimmed with the vehicle power switched ON. If the instrument cluster's visibility is reduced due to glare from surrounding brightness, cancel the illumination dimmer.

Outside Temperature Display

When the vehicle power is switched ON, the outside temperature is displayed.

 

 


The outside temperature display may differ from the actual outside temperature depending on the surroundings and vehicle conditions.

How to Use the Average Fuel Economy Display

To reset the displayed average fuel economy data, press the INFO switch for 2 seconds or longer.

After resetting the data, - - - L/100 km (- - - mpg) is displayed until the average fuel economy is recalculated and displayed.

i-ACTIVSENSE Display

Displays the system status.

 

Compass Display

The direction the vehicle is moving is displayed in one of eight directions while the vehicle is being driven.

 

Roof Operation Display (Hardtop)

Displays the roof operation status.

Page top