Instrument Cluster
Speedometer
The speedometer indicates the speed of the vehicle.
Tachometer
The tachometer shows engine speed in thousands of revolutions per minute (rpm).
Do not run the engine with the tachometer needle in the RED ZONE.
This may cause severe engine damage.
-
STRIPED ZONE
-
RED ZONE
When the tachometer needle enters the STRIPED ZONE, this indicates to the driver that the gears should be shifted before entering the RED ZONE.
Multi-information Display
The screen display informs you of the vehicle information.
The multi-information display indicates the following information.
-
Odometer
-
Trip meter
-
Engine coolant temperature gauge
-
Fuel gauge
-
Outside temperature
-
Maximum driving distance
-
Average fuel economy
-
Current fuel economy
-
i-ACTIVSENSE display
-
Door-ajar/trunk lid-open warning indication*1
-
Compass Display
-
Roof Operation Display (Hardtop)
-
Message display
-
Displayed when opening door/trunk lid.
Odometer/Trip Meter
Odometer
The odometer records the total distance the vehicle has been driven.
Trip meter
The driving distance for a specified interval is indicated. Two types (TRIP A, TRIP B) of interval distance can be measured.
Fuel Gauge
The fuel gauge shows approximately how much fuel is remaining in the tank when the vehicle power is switched ON.
When the fuel tank is full, F (Full) is indicated, and as the level lowers the needle approaches E (Empty).
-
After refueling, it may require some time for the indicator to stabilize. In addition, the indicator may deviate while driving on a slope or curve since the fuel moves in the tank.
-
The direction of the arrow
indicates that the fuel-filler lid is on the left side of the vehicle.
How to Use the Dashboard Illumination
-
Dim
-
Bright
A beep sound will be heard when the knob has been rotated to the maximum dim position.
Function for canceling illumination dimmer
The illumination dimmer can be cancelled by rotating the instrument panel illumination knob to the right until a beep sound is heard while the instrument cluster is dimmed with the vehicle power switched ON. If the instrument cluster's visibility is reduced due to glare from surrounding brightness, cancel the illumination dimmer.
Maximum Driving Distance Display
The maximum driving distance is calculated and displayed based on the current remaining fuel tank level and the fuel economy. When the maximum driving distance is 50 km (30 miles) or farther, the maximum driving distance indication decreases in 10 km (10 mile) increments, and when the maximum driving distance is shorter than 50 km (30 miles), it decreases in 1 km (1 mile) increments.
The maximum driving distance is just an approximate numerical value and differs from the actual driving distance. Drive the vehicle while checking the fuel gauge.
Average Fuel Economy Display
This mode displays the average fuel economy by calculating the total traveled distance and the total fuel consumption since the vehicle was purchased or the past data was reset. The average fuel economy is calculated and displayed every 30 seconds.
How to Use the Average Fuel Economy Display
To reset the displayed average fuel economy data, press the INFO switch for 2 seconds or longer.
After resetting the data, - - - L/100 km (- - - mpg) is displayed until the average fuel economy is recalculated and displayed.
Instantaneous Fuel Economy Display
This displays the current fuel economy by calculating the amount of fuel consumption and the distance traveled.
Displays the 0 position when the vehicle speed decreases to a constant speed or slower.
Message Display
Displays a message to notify the user of the system operation status and malfunctions or abnormalities.
Follow the instructions indicated on the display.
Refer to How to Use the Multi-information Display (Search).
