Windows
Power Windows
The windows can be opened/closed by operating the power window switches.
Make sure the opening is clear before closing a window:
Closing a power window is dangerous. A person's hands, head, or even neck could be caught by the window and result in serious injury or even death. This warning applies especially to children.
Never allow children to play with power window switches:
Power window switches that are not locked with the power window lock switch would allow children to operate power windows unintentionally, which could result in serious injury if a child's hands, head or neck becomes caught by the window.
Make sure nothing blocks the window just before it reaches the fully closed position or while fully holding up the power window switch:
Blocking the power window just before it reaches the fully closed position or while fully holding up the power window switch is dangerous.
In this case, the jam-safe function cannot prevent the window from closing all the way. If fingers are caught, serious injuries could occur.
When driving with only 1 of the rear windows open, your ears might experience a resonating sound. However, this does not indicate a problem. The sound can be reduced by slightly opening a front window or by changing the size of the rear window opening.
Opening/Closing Windows
Auto-opening/Closing
To fully open the window automatically, press the switch completely down, then release. The window will fully open automatically.
To fully close the window automatically, pull the switch completely up, then release. The window will fully close automatically.
To stop the window partway, pull or press the switch in the opposite direction and then release it.
Power window system initialization procedure
If the battery was disconnected during vehicle maintenance, or for other reasons (such as a switch continues to be operated after the window is fully open/closed), the window will not fully open and close automatically.
The power window auto function will only resume on a power window that has been reset.
-
Switch the ignition ON.
-
Make sure that the power window lock switch located on the driver's door is not depressed.
-
Press the switch and fully open the window.
-
Pull up the switch to fully close the window and continue holding the switch for about 2 seconds after the window fully closed.
-
Make sure that the power windows operate correctly using the door switches.
After the system has been re-initialized, each passenger window can be fully opened or closed automatically using the master control switches.
Jam-safe Moonroof
If a person's hands, head or an object blocks the moonroof while it is closing, the moonroof will stop and move in the open direction.
-
The jam-safe function may operate under the following conditions:
-
A strong impact is detected while the moonroof is closing automatically.
-
The moonroof is closing automatically during very low temperatures.
-
-
In the event the jam-safe function activates and the moonroof cannot be closed automatically, press the tilt/slide switch and the moonroof will close.
-
The jam-safe moonroof function does not operate until the system has been reset.