Owner Maintenance

Hood

Hood

 

Always check that the hood is closed and securely locked:

A hood that is not closed and securely locked is dangerous as it could fly open while the vehicle is moving and block the driver's vision which could result in a serious accident.

Close Warning
View Warning

Closing the Hood

  1. Check under the hood area to make certain all filler caps are in place and all loose items (e.g. tools, oil containers, etc.) have been removed.

  2. Lift the hood, grasp the padded area on the support rod, and secure the support rod in the clip. Verify that the support rod is secured in the clip before closing the hood.

     

  3. Lower the hood slowly to a height of about 20 cm (7.9 in) above its closed position and then let it drop.

 

When closing the hood, do not push it excessively such as by applying your weight. Otherwise, the hood could be deformed.

Close Caution
View Caution
Engine Oil

Engine Oil

 

Changing the engine oil should be performed by an Authorized Mazda Dealer.

Refer to Introduction (Search) for owner's responsibility in protecting your investment.

Close Note
View Note
Washer Fluid

Inspecting Washer Fluid Level

 

Use only windshield washer fluid or plain water in the reservoir:

Using radiator antifreeze as washer fluid is dangerous. If sprayed on the windshield, it will dirty the windshield, affect your visibility, and could result in an accident.

Using Washer Fluid Without Anti-freeze Protection in Cold Weather:

Operating your vehicle in temperatures below 4 degrees C (40 degrees F) using washer fluid without anti-freeze protection is dangerous as it could cause impaired windshield vision and result in an accident. In cold weather, always use washer fluid with anti-freeze protection.

Close Warning
View Warning

 

State or local regulations may restrict the use of volatile organic compounds (VOCs), which are commonly used as anti-freeze agents in washer fluid. A washer fluid with limited VOC content should be used only if it provides adequate freeze resistance for all regions and climates in which the vehicle will be operated.

Close Note
View Note

Inspect fluid level in the washer fluid reservoir; add fluid if necessary.

 

Use plain water if washer fluid is unavailable.

But use only washer fluid in cold weather to prevent it from freezing.

 

Front and rear washer fluid is supplied from the same reservoir.

Close Note
View Note
Body Lubrication

Body Lubrication

All moving points of the body, such as door and hood hinges and locks, should be lubricated each time the engine oil is changed. Use a nonfreezing lubricant on locks during cold weather.

 

Make sure the hood's secondary latch keeps the hood from opening when the primary latch is released.

Page top