Driving Tips
Break-In Period
Break-In Period
No special break-in is necessary, but if unnecessary hard stops are avoided in the first 1,000 km (600 miles), it may add to the performance, economy, and life of the vehicle.
Hazardous Driving
Hazardous Driving
Be careful when applying sudden regenerative braking on slippery surfaces:
The sudden change in tire speed could cause the tires to skid. This could lead to loss of vehicle control and an accident.
When driving on ice or in water, snow, mud, sand, or similar hazards:
-
Be cautious and allow extra distance for braking.
-
Avoid sudden braking and sudden maneuvering.
-
Do not pump the brakes. Continue to press down on the brake pedal.
Refer to Antilock Brake System (ABS) (Search).
-
For more traction in starting on slippery surfaces such as ice or packed snow, use sand, rock salt, chains, carpeting, or other nonslip material under the front wheels.
Floor Mat
Rocking the Vehicle
Winter Driving
Snow Tires
Use snow tires on all 4 wheels
Do not go faster than 120 km/h (75 mph) while driving with snow tires. Inflate snow tires 30 kPa (0.3 kgf/cm2, 4.3 psi) more than recommended on the tire pressure label (rear door on the driver's side), but never more than the maximum cold-tire pressure shown on the tires.
The vehicle is originally equipped with all season radials designed to be used all year around. In some extreme climates you may find it necessary to replace them with snow tires during the winter months to further improve traction on snow and ice covered roads.
Use only the same size and type tires (snow, radial, or non-radial) on all 4 wheels:
Using tires different in size or type is dangerous. Your vehicle's handling could be greatly affected and result in an accident.
The tire pressure monitoring system may not function correctly when using tires with steel wire reinforcement in the sidewalls (Search).
Tire Chains
Check local regulations before using tire chains.
-
Chains may affect handling.
-
Do not go faster than 50 km/h (30 mph) or the chain manufacturer's recommended limit, whichever is lower.
-
Drive carefully and avoid bumps, holes, and sharp turns.
-
Avoid locked-wheel braking.
-
Do not use chains on a temporary spare tire; it may result in damage to the vehicle and to the tire. Your vehicle is not equipped with a factory installed temporary spare tire.
-
Do not use chains on roads that are free of snow or ice. The tires and chains could be damaged.
-
Chains may scratch or chip aluminum wheels.
-
The tire pressure monitoring system may not function correctly when using tire chains.
Install the chains on the front tires only.
Do not use chains on the rear tires.
Please consult an Authorized Mazda Dealer.
Installing the chains
-
Secure the chains on the front tires as tightly as possible.
Always follow the chain manufacturer's instructions.
-
Retighten the chains after driving 1/2―1 km (1/4―1/2 mile).
Overloading
Be careful not to overload your vehicle:
The gross axle weight rating (GAWR) and the gross vehicle weight rating (GVWR) of the vehicle are on the Motor Vehicle Safety Standard Label on the driver's door frame. Exceeding these ratings can cause an accident or vehicle damage. You can estimate the weight of the load by weighing the items (or people) before putting them in the vehicle.
