Switches and Controls
Headlight High-Low Beam
Flashing the Headlights
When the power switch is switched ON, and regardless of the headlight position, the headlights switch to high beams while the lever is being pulled.
-
OFF
-
Headlight flashing
The headlight high-beam indicator light in the instrument cluster illuminates simultaneously. The lever will return to the normal position when released.
Leaving Home Light
The leaving home light turns on the lights when the transmitter unlock button is pressed while away from the vehicle.
The following lights turn on when the leaving home light is operated.
Low beams, Parking lights, Taillights, License plate lights.
To turn on the lights
The headlights and the exterior lights turn on when the unlock switch on the key is pressed and the vehicle receives the key signal with the power switch and the headlight switch under the following conditions:
-
Power switch: OFF
-
Headlight switch: AUTO,
, or 
The headlights turn off after a certain period of time has elapsed (30 seconds).
-
Lock button
-
Unlock button
-
Operation of the leaving home light can be turned on or off.
Refer to the Settings section in the Mazda Connect Owner's Manual.
-
When the transmitter lock button is pressed and the vehicle receives the transmitter signal, the headlights turn off.
-
When the headlight switch is turned to the OFF position, the headlights turn off.
Windshield Wipers and Washer
Rear Window Wiper
Turn the wiper on by turning the rear wiper/washer switch.
|
Switch Position |
Wiper operation |
|---|---|
 |
Spray washer fluid and operate the rear wiper |
|
ON |
Normal |
|
INT |
Intermittent |
|
OFF |
Stop |
|
Spray washer fluid and operate the rear wiper |
Mirror Defogger (Some Models)
The mirror defoggers defrost the outside mirrors.
The mirror defoggers operate in conjunction with the rear window defogger.
Press the rear window defogger switch when the power switch is switched ON to operate the mirror defoggers (Search).
-
Indicator light
Reprogramming the HomeLink system
To program a device to HomeLink using a HomeLink button previously trained, follow these steps:
-
Press and hold the desired HomeLink button. DO NOT release the button.
-
After 20 seconds, the indicator light flashes in amber. After the indicator light flashes, release the HomeLink button.
-
Go back to Step 2 of Programming the HomeLink System to complete the procedure.
If the programming has not been completed, the system returns to the previous programming.
