Interior Equipment
Sunvisors
Sunvisors
Lower the sunvisor to block sunlight from the front.
To block sunlight from the side, lower and unhook the sunvisor, and then swing it to the side.
Side Extension Sunvisors
The visor extender extends the sunvisor's range of sun shading.
To use, pull it out.
When moving the sunvisor, retract the visor extender to its original position. Otherwise, the visor extender could hit the rearview mirror.
Vanity Mirrors
The vanity mirror is on the backside of the sunvisor.
If your vehicle is equipped with a vanity mirror light, it will illuminate when you open the cover.
The vanity mirror will only illuminate in the tilt range shown in the figure.
-
Vanity mirror light
-
On
-
Off
If a vanity mirror light is left on with the power switch switched OFF, the light is turned off automatically to prevent the lead-acid battery from being discharged.
The vanity mirror light can be turned on again by doing any of the following operations:
-
Opening/closing any door.
-
Unlocking any door.
-
Switching the power switch to ACC or ON.
-
Switching an overhead light/front map light on.
Interior Lights
Interior Lights
Do not leave the lights on for long periods while the EV system is stopped. Otherwise the lead-acid battery power could be depleted.
Overhead lights
Front
-
Indicator light
|
Switch |
Overhead Lights |
|---|---|
 ON/OFF |
Press the switch to turn it on. Press the switch again to turn off the lights. |
 DOOR OFF |
The door interlock can be switched ON/OFF. When the door interlock is OFF, the indicator light in the switch turns on.
Door interlock ON (indicator light in switch is off)
|
Rear
(Vehicles without rear map lights)
(Vehicles with rear map lights)
The rear overhead light also turn on and off when the front overhead light switch is operated.
Map lights
Front
Press the switch to illuminate the front map lights, and then press the switch again to turn them off.
The front map lights will not turn off even if the switch is pressed in the following cases:
-
The overhead lights turn on by operating the overhead light ON/OFF switch (
). -
The overhead lights turn on in conjunction with a door opening/closing.
-
The illuminated entry system is on.
Rear (Some Models)
When the overhead light ON/OFF switch () is off, press the switch to illuminate the rear map lights, and then press the switch again to turn them off.
-
Once the rear map lights have been turned off, they will turn on and off in conjunction with the overhead light operation.
-
The rear map lights will not turn off even if the switch is pressed in the following cases:
-
The overhead lights turn on by operating the overhead light ON/OFF switch (
). -
The overhead lights turn on in conjunction with a door opening/closing.
-
The illuminated entry system is on.
-
Luggage compartment light
The luggage compartment light is on when the liftgate is open and off when it is closed.
Do not leave the liftgate open for long periods while the EV system is stopped. Otherwise the lead-acid battery power could be depleted.
Illuminated Entry System
The overhead lights turn on when any of the following operations is done with the overhead light switch in the DOOR position.
-
The driver's door is unlocked with the power switch switched OFF.
-
The power switch is switched OFF with all doors closed.
-
The illumination time differs depending on the operation.
-
The vehicle is equipped with a battery saver. If an interior light is left on with the power switch switched OFF, the light turns off automatically after a certain period of time has passed to prevent lead-acid battery depletion.
-
The operation of the illuminated entry system can be changed.
Refer to the Settings section in the Mazda Connect Owner's Manual.
-
The illuminated entry system does not operate in conjunction with the overhead lights when the overhead lights are turned on using the overhead light ON/OFF switch.
Accessory Sockets
Accessory Sockets
Only use genuine Mazda accessories or the equivalent requiring no greater than 120 W (DC 12 V, 10 A).
The power switch must be switched to ACC or ON.
Connecting the accessory socket
-
Open the lid.
-
Pass the connection plug cord through the cutout of the console and insert the plug into the accessory socket.
-
Plug
-
-
To prevent accessory socket damage or electrical failure, pay attention to the following:
-
Do not use accessories that require more than 120 W (DC 12 V, 10 A).
-
Do not use accessories that are not genuine Mazda accessories or the equivalent.
-
Close the cover when the accessory socket is not in use to prevent foreign objects and liquids from getting into the accessory socket.
-
Correctly insert the plug into the accessory socket.
-
Do not insert the cigarette lighter into the accessory socket.
-
-
Noise may occur on the audio playback depending on the device connected to the accessory socket.
-
Depending on the device connected to the accessory socket, the vehicle's electrical system may be affected, which could cause the warning light to illuminate. Disconnect the connected device and make sure that the problem is resolved. If the problem is resolved, disconnect the device from the socket and switch the power switch off. If the problem is not resolved, consult an Authorized Mazda Dealer.
To prevent the lead-acid battery from depleting, do not use the socket for long periods with the EV system stopped.
AC Power Outlet (Some Models)
AC Power Outlet (120 V/150 W)
The AC power outlet can be used as a socket for accessories when the power switch is switched to ACC or ON.
Only use AC 120 V/60 Hz accessories that have a maximum power consumption of 150 W or below.
Never use medical instruments with the power outlet:
Otherwise, the operation of the medical device might be affected.
Heed the following cautions when using the AC power supply to prevent electrical shock, smoking, or combustion.
-
Be careful with the AC power outlet and plug during and after use.
-
Because an electrical appliance could operate at the moment it is plugged in, check the safety before plugging it in.
-
Do not plug accessories into the power outlet or unplug them with wet hands.
-
Be careful not to allow liquid to penetrate the AC power outlet.
-
Do not put anything other than plugs into the AC power outlet.
-
Do not disassemble the AC power outlet.
-
Do not use the AC power outlet if it is damaged. If part replacement or repair is required, consult an Authorized Mazda Dealer.
-
Always close the cover when it is not in use. If foreign matter or liquid penetrates the AC power outlet, it may cause a problem.
-
Insert electrical appliance plugs into the AC power outlet securely. If the plug is not inserted securely, it may heat excessively and blow a fuse.
-
Do not connect multiple electrical appliances to the AC power outlet. Otherwise, it could cause smoking or combustion.
-
Do not use electrical appliances that exceed the prescribed power capacity. Otherwise, it could cause a malfunction.
To prevent the lead-acid battery from depleting, do not use the socket for long periods with the EV system stopped.
How to connect
-
Open the lid.
-
Connect the plug to the AC power outlet.
-
Plug
-
-
Use electrical appliances only in the cabin. If they are used outside of the vehicle cabin, they may not operate correctly due to noise.
-
The following electrical appliances may not operate even if their electrical capacity is 150 W or lower.
-
Appliances requiring large amounts of power for activation (such as refrigerators with a compressor, electrical pumps, and electrical tools)
-
Appliances with a power supply frequency switch function (such as clocks and audio)
-
Appliances for precise data processing (such as measurement equipment)
-
-
Electrical appliances other than the above may not be used.
-
When using an electrical appliance for data processing such as a personal computer, back up the data frequently.
-
The protection function operates and the AC power outlet cannot be used in the following cases:
-
Battery power is weak
-
Appliances with a capacity of 150 W or higher are used
-
Cabin temperature is extremely hot
-
-
Noise may occur during radio operation depending on the electrical appliance being used.
Front
Rear (Some Models)
The rear cup holder is on the rear center armrest.
Bottle Holder
Bottle holders are on the inside of the doors.
-
Bottle holder
Do not use the bottle holders for containers without caps. The contents may spill when opening/closing the door or while driving the vehicle.
Assist Grips
Assist Grips
Never hang heavy or sharp objects on the assist grips and coat hooks:
Hanging heavy or sharp-ended objects such as a coat hanger from the assist grips or coat hooks is dangerous as they can fly off and hit an occupant in the cabin if a curtain air bag was to deploy, which could result in serious injury or death.
Do not use the assist grips when getting in and out of the vehicle or getting out of a seat:
An assist grip could break under a heavy load resulting in injury.
Use the assist grips to support your body while seated in the vehicle and while the vehicle is moving.
Rear Coat Hooks
Rear Coat Hooks
Never hang heavy or sharp objects on the assist grips and coat hooks:
Hanging heavy or sharp-ended objects such as a coat hanger from the assist grips or coat hooks is dangerous as they can fly off and hit an occupant in the cabin if a curtain air bag was to deploy, which could result in serious injury or death.
Always hang clothes on the coat hooks and the assist grips without hangers.
Storage Compartments
Storage Compartments
Keep storage boxes closed when driving:
Driving with the storage boxes open is dangerous. To reduce the possibility of injury in an accident or a sudden stop, keep the storage boxes closed when driving.
When loading cargo, make sure that it is completely secured:
If the cargo is not completely secured, it may move or collapse while driving or during sudden braking, resulting in injury or an accident.
Do not put articles in storage spaces with no lid:
Putting articles in storage spaces with no lid is dangerous as they could be thrown around the cabin during sudden braking, maneuvering, or acceleration and cause an accident depending on how the article is stored.
Do not leave lighters or eyeglasses in the storage boxes while parked under the sun. A lighter could explode or the plastic material in eyeglasses could deform and crack from high temperature.
Overhead Console (Some Models)
This console box is designed to store eyeglasses or other accessories.
Push and release to open.
Storage Pocket
To use, open the lid.
Glove Compartment
To open the glove compartment, pull the latch toward you.
To close the glove compartment, firmly press in the center of the glove compartment lid.
Center Console
To open the lid, slide it all the way back, pull the lever, and then lift the lid up.
Do not put your hands or fingers around the moving parts of the lid when using the lid. Otherwise, your hand or finger could get caught, resulting in an injury.
