Interior Equipment
Sunvisors
Vanity Mirrors
The vanity mirror is on the backside of the sunvisor.
If your vehicle is equipped with a vanity mirror light, it will illuminate when you open the cover.
The vanity mirror will only illuminate in the tilt range shown in the figure.
-
Vanity mirror light
-
On
-
Off
If a vanity mirror light is left on with the power switch switched OFF, the light is turned off automatically to prevent the lead-acid battery from being discharged.
The vanity mirror light can be turned on again by doing any of the following operations:
-
Opening/closing any door.
-
Unlocking any door.
-
Switching the power switch to ACC or ON.
-
Switching an overhead light/front map light on.
Accessory Sockets
Only use genuine Mazda accessories or the equivalent requiring no greater than 120 W (DC 12 V, 10 A).
The power switch must be switched to ACC or ON.
Connecting the accessory socket
-
Open the lid.
-
Pass the connection plug cord through the cutout of the console and insert the plug into the accessory socket.
-
Plug
-
-
To prevent accessory socket damage or electrical failure, pay attention to the following:
-
Do not use accessories that require more than 120 W (DC 12 V, 10 A).
-
Do not use accessories that are not genuine Mazda accessories or the equivalent.
-
Close the cover when the accessory socket is not in use to prevent foreign objects and liquids from getting into the accessory socket.
-
Correctly insert the plug into the accessory socket.
-
Do not insert the cigarette lighter into the accessory socket.
-
-
Noise may occur on the audio playback depending on the device connected to the accessory socket.
-
Depending on the device connected to the accessory socket, the vehicle's electrical system may be affected, which could cause the warning light to illuminate. Disconnect the connected device and make sure that the problem is resolved. If the problem is resolved, disconnect the device from the socket and switch the power switch off. If the problem is not resolved, consult an Authorized Mazda Dealer.
To prevent the lead-acid battery from depleting, do not use the socket for long periods with the EV system stopped.
AC Power Outlet (Some Models)
AC Power Outlet (120 V/150 W)
The AC power outlet can be used as a socket for accessories when the power switch is switched to ACC or ON.
Only use AC 120 V/60 Hz accessories that have a maximum power consumption of 150 W or below.
Never use medical instruments with the power outlet:
Otherwise, the operation of the medical device might be affected.
Heed the following cautions when using the AC power supply to prevent electrical shock, smoking, or combustion.
-
Be careful with the AC power outlet and plug during and after use.
-
Because an electrical appliance could operate at the moment it is plugged in, check the safety before plugging it in.
-
Do not plug accessories into the power outlet or unplug them with wet hands.
-
Be careful not to allow liquid to penetrate the AC power outlet.
-
Do not put anything other than plugs into the AC power outlet.
-
Do not disassemble the AC power outlet.
-
Do not use the AC power outlet if it is damaged. If part replacement or repair is required, consult an Authorized Mazda Dealer.
-
Always close the cover when it is not in use. If foreign matter or liquid penetrates the AC power outlet, it may cause a problem.
-
Insert electrical appliance plugs into the AC power outlet securely. If the plug is not inserted securely, it may heat excessively and blow a fuse.
-
Do not connect multiple electrical appliances to the AC power outlet. Otherwise, it could cause smoking or combustion.
-
Do not use electrical appliances that exceed the prescribed power capacity. Otherwise, it could cause a malfunction.
To prevent the lead-acid battery from depleting, do not use the socket for long periods with the EV system stopped.
How to connect
-
Open the lid.
-
Connect the plug to the AC power outlet.
-
Plug
-
-
Use electrical appliances only in the cabin. If they are used outside of the vehicle cabin, they may not operate correctly due to noise.
-
The following electrical appliances may not operate even if their electrical capacity is 150 W or lower.
-
Appliances requiring large amounts of power for activation (such as refrigerators with a compressor, electrical pumps, and electrical tools)
-
Appliances with a power supply frequency switch function (such as clocks and audio)
-
Appliances for precise data processing (such as measurement equipment)
-
-
Electrical appliances other than the above may not be used.
-
When using an electrical appliance for data processing such as a personal computer, back up the data frequently.
-
The protection function operates and the AC power outlet cannot be used in the following cases:
-
Battery power is weak
-
Appliances with a capacity of 150 W or higher are used
-
Cabin temperature is extremely hot
-
-
Noise may occur during radio operation depending on the electrical appliance being used.
Cup Holder
Bottle Holder
Bottle holders are on the inside of the doors.
-
Bottle holder
Do not use the bottle holders for containers without caps. The contents may spill when opening/closing the door or while driving the vehicle.
Storage Compartments
Glove Compartment
Center Console
To open the lid, slide it all the way back, pull the lever, and then lift the lid up.
Do not put your hands or fingers around the moving parts of the lid when using the lid. Otherwise, your hand or finger could get caught, resulting in an injury.
