Specifications
Specifications
Charge System
|
Item |
Servicing data |
|---|---|
|
Input power |
110 - 240 V AC |
|
Rated frequency |
60 Hz |
|
Maximum rated electrical current |
32 A (normal charge) |
|
Maximum power consumption |
7.2 kVA (normal charge) |
|
Maximum charging current |
150 A (quick charge) |
|
Electrical leakage detection current for control box including genuine charge cable |
5 mA |
|
EV charge mode/Connection type |
Normal charge: AC Level 1, AC level 2 Quick charge: CCS1 (Combo1) Connection Type : TYPE1 |
|
Installation requirements (information on protection against short-circuit current and equipment protection) |
Applicable laws and regulations, and standards must be followed for protection measures against over-current and over-voltage. Always make sure to install appropriate over-current protection devices to the wiring of houses and buildings. |
|
IP level |
IP44: When charge connector is connected to charge inlet IP67: EV Supply Equipment(Charging Cable) |
|
Operating temperature |
Onboard charger: －30 °C (－22 °F) ― 85 °C (185 °F) (ambient temperature), －30 °C (－22 °F) ― 65 °C (149 °F) (coolant temperature) EV Supply Equipment(Charging Cable) : －30 °C (－22 °F) ― 55 °C (131 °F) (ambient temperature) |
|
Storage temperature |
Onboard charger: －40 °C (－40 °F) ― 85 °C (185 °F) (coolant temperature), －40 °C (－40 °F) ― 85 °C (185 °F) (ambient temperature) EV Supply Equipment(Charging Cable) : －40 °C (－40 °F) ― 80°C (176 °F) (ambient temperature) |
|
Applicable standards |
Onboard charger: EN/IEC 61851-1, EN/IEC 61851-21, EN/IEC 61851-23, UL 2202 EV Supply Equipment(Charging Cable) : NFPA 70, NFPA 79, SAE-J 1772, UL 62, UL 817, UL 2231-1, UL 2231-2, UL 2251, UL 2594, CSA C22.2 No.280-16 |
|
Adapters |
Do not use an adapter on the charge plug and the charge connector. Do not use an extension cable. |
High Voltage Battery
Lead-acid Battery
|
Item |
Specification |
|
|---|---|---|
|
Lead-acid battery*1 |
LN1 (12V-42Ah/20HR) |
|
-
Check the battery installed on the vehicle and use a battery with an equal or higher performance. However, the performance of the battery may vary even among the same battery types, consult an Authorized Mazda Dealer for replacement.
Lubricant Quality
|
Lubricant |
Classification |
|---|---|
|
Coolant |
FL-22 type |
|
EV Transaxle fluid |
Mazda Original Oil ATF-FZ |
|
Brake fluid |
SAE J1703 or FMVSS116 DOT-3 |
Capacities
(Approximate Quantities)
|
Item |
Capacity |
|---|---|
|
Coolant |
4.3 L (4.5 US qt, 3.8 Imp qt) |
|
EV Transaxle fluid |
1.55 L (1.64 US qt, 1.36 Imp qt) |
Check oil and fluid levels with dipsticks or reservoir gauges.
Dimensions
|
Item |
Vehicle specification |
|---|---|
|
Overall length |
4,393 mm (173.0 in) |
|
Overall width |
1,797 mm (70.7 in) |
|
Overall height |
1,574 mm (62.0 in) |
|
Front tread |
1,563 mm (61.5 in) |
|
Rear tread |
1,563 mm (61.5 in) |
|
Wheelbase |
2,653 mm (104.4 in) |
Weights
|
Item |
Weight |
|
|---|---|---|
|
GVWR (Gross Vehicle Weight Rating) |
2,087 kg (4,601 lbs) |
|
|
GAWR (Gross Axle Weight Rating) |
Front |
1,047 kg (2,308 lbs) |
|
Rear |
1,042 kg (2,297 lbs) |
|
Light Bulbs
Exterior light/Interior light
All the light bulbs are the LED type.
The LED bulb cannot be replaced. Consult an Authorized Mazda Dealer when the replacement is necessary.
Tires
The tires have been optimally matched with the chassis of your vehicle.
When replacing tires, Mazda recommends that you replace tires of the same type originally fitted to your vehicle. For details, contact an Authorized Mazda Dealer.
Check the tire pressure label for tire size and inflation pressure.
-
Refer to Tire Pressure Label (Search).
Standard tire
|
Tire size |
Inflation pressure |
|
|---|---|---|
|
Front |
Rear |
|
|
215/55R18 95H M+S |
250 kPa (36 psi) |
250 kPa (36 psi) |
Lug nut tightening torque
When installing a tire, tighten the lug nut to the following torque.
108―147 N·m (12―14 kgf·m, 80―108 ft·lbf)
Fuses
Refer to Fuses (Search).
